digital satellite finde rmeter surport DVB-S/S2 DVB-S DVB-T

3.5Inch TFT LED Handheld Multifunctional HD Satellite Finder&Monitor

*3.5 Inch High definition TFT LCD Screen which Can Play Channels(DVB-S/S2)

*Live FTA Digital Picture and Sound,

*AV Output and AV Input function.

*Shows strength and quality readings,

*LED digital tube:Synchronous display,

*Sound and Light Alarm When Lock Signal.(DVB-S/S2 MPEG-4 ABS-S) 

1. Appearance

1.1   ,Panel (Figure 1)

1, LCD display: Show images and other signals.

2,LED Signal light: A signal shows green.

3, 0-9: Number Key.

4, TV / AV:TV/AV function switch

5, INFO: The key enters the status of shifting starts, showing the information of signal strength and quality.

6, MENU: Press to enter  the menu.                  

7, VOLt: To turn down the volume or move the cursor 1eft.

8, CHq: To turn down the channel or move the cursor down.

9, OK / M: In TV receiving state,press to confirm; hold to enter main menu to adjust image parameters. In AV receiving state, press to enter main menu to adjust image parameters.

10, VOLu:To turn up the volume or move the cursor right.

11, CH:To turn up the channel or move the cursor up.

12, LED power light: Red when power is on.

1.2, Bottom(Figure2)

1, LNB IN: The satellite signal input socket.

2, Upgrade port:for software upgrade; please remove the small plastic button while using.

3, VIDEO:  output/ input video signals.

4, AUDIO: Input/ output left/Right

-channel audio signals.         5, power switch: “0” – off, “I” – on.                    (Figure 2)

6, DC 8.5V: Direct power supply (DC 8.5V) input jack.

7, the battery compartment board: slide the battery cover down, to open the battery box to replace the battery.

nd: Open to stand the machine.

9, Speaker: speaker output port.

2.Power Supply

   2.1,Built-in Battery Pack power supply:

The machine built-in 7.4V, 2000mAh high-performance lithium polymer battery. Turn on the power switch, built-in battery pack directly on the machine power supply, user-friendly electricity in the outdoors or where there is no normal use of the machine. The machine, after the battery is full, the AV input state is not less than 12 consecutive working when the satellite TV receiving state in the continuous work of not less than 2 hours.

    The battery with intelligent protection circuit to avoid the damage by over-recharge/over -discharge or short-circuit. Please recharge the battery with the attached power adapter, when the power light is red(Suggestion: to charge the battery over 8-10 hours before, use the unit. The battery can achieve best function after recharge/discharge 2-3 times.).

2.2, External power adapter: please use power adapter we supply, connect the power DC8.5V at the rear panel to charge.

  2.3, Car power supply

(optional)

   Connect the power supply with car cigarette lighter, then light turn red, showing they are connected correctly,      

please connect the power supply into this DC jack, so that you can supply power into the machine or charge the battery.

 

Contact us if you need more details on Digital Satelliter Finder. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Digital Satelliter Receiver、Analog to Digital Converter Dvb-t. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Ungrouped